RGB LEDs require more electrical components than a standard electrical LED and are often more confusing to install. If you are struggling with installation of RGB LEDs for your sign read below for some helpful tips.
![](https://signfab.com/wp-content/uploads/2023/07/sloanled-spectrum-rgbw-module-application-channel-letters.png)
What you need:
- Power supply
- RGB Controller
- Amplifier
- Remote
Installing one run of RGBs:
- Take your power supply and connect it to the RGB Controller.
- Next, connect your RGB controller to the LED wires.
For single power supply application, you will not need an amplifier.
Installing more than one run of RGBs:
- Take your power supply and connect it to the RGB Controller.
- Next, connect your RGB controller to the amplifier according to color.
Input – V+ =Black, R = Red, G = Green, B = Yellow and W = White - Connect your second power supply to the amplifier – Power V+ (Red) and V- (Black).
- On the same side as your second power supply (Output), connect RGB wires according to color.
W = white, B = Yellow, G = Green, R = Red, V+ = Black
Visual diagram explains how to hook up to a single power supply and then route to two or more power supplies.
If you are unsure or still have questions about installation don’t hesitate to call 800-544-6381 or email [email protected]. We are always here to help with anything you need.